Lumenblade Small
Add to your Selection:
Minimalist LED for Outdoor Sites and Areas
The Lumenpulse Lumenblade Small is an outdoor LED luminaire that uses a rectilinear version of the Lumencentro light engine to create a continuous line of light. Its seen-but-not-seen, minimalist design is sustainable, blends with both contemporary and heritage architectures, provides a high level of security, and is sensitive to the natural environment. The Lumenblade Small is available in several lengths, a number of distributions, output options, and DarkSky approval provide a stellar quality of light that brings the night to life.
Downloads
Documents (0)
0.00/250 MB
Product Configurator
Your Product Code
BLDS SD __ CSL __ __ __ __ __ __ __
Housing
Mounting
Voltage
Lens 3
Output (Nominal Lumens)
Color and Color Temperature
Distributions
Finish
Option
Pole Mounting Adaptor 25
Notes
- 1 Product code is for a single fixture only (S1E configuration). For double configuration (S2E), a second product code must be completed.
- 2 Not available with LT control option.
- 3 Consult factory for Softsite Lens option. Available for 3000lm (1 board), 5000lm (2 boards) and 7000lm (3 boards) outputs.
- 4 Motion detector options add 5 1/8 in to total length of fixture.
- 5 Available up to 277V.
- 6 Available for CRI 80 only.
- 7 Available for CRI 80 and CRI 90 only.
- 8 Not DarkSky Approved.
- 9 Available for CRI 70 and CRI 80 only.
- 10 Binning within a 3-step McAdam ellipse, with the exception of 5700K.
- 11 Binning within a 2-step MacAdam ellipse, with the exception of 2200K and 5700K.
- 12 Binning within a 2-step MacAdam ellipse.
- 13 Specify RAL number followed by “TX” for textured finish (ex: RAL9007TX) or STX for Sandtex finish (ex: RAL9007STX). Textured or Sandtex finishes are recommended for the durability of all products. If a finish is not specified with the RAL number (ex: RAL9007), a glossy finish will be provided. Please consult factory for other RAL textures and glosses, or to match alternate color charts. Final color matching results may vary.
- 14 Setup charges apply for RAL colors. Consult factory for details.
- 15 Longer lead times can be expected for custom RAL color finishes.
- 16 DIM control can be used as NO (On/Off control) if no data is required.
- 17 Not available with SPR3, SPR3 SC, SPR5, SPR5 SC, SPR7 and SPR7 SC 3-Pin, 5-Pin, and 7-Pin receptacles options and MD10N, MD30N, MD50N and MDPN motion detector options.
- 18 Use only when exposed to salt spray. This option is not required for normal outdoor exposure.
- 19 Setup charges apply. Consult factory for details.
- 20 Not available with 347V and 480V voltage options when combined with lumen output S40.
- 21 Only one receptacle can be specified per fixture, cannot be combined with motion detector option.
- 22 The motion detector programming can be modified on site. A remote is required, order separately. See Remote section in the specification sheet for details.
- 23 Only one motion detector can be specified per fixture, cannot be combined with a receptacle.
- 24 The motion detector is programmed in the factory, as per the settings requested at the time of the order.
- 25 Consult Pole Mounting Adaptor section for standard available configurations.